As in any swimming pool you must monitor the pH and TA weekly (maintain the water chemistry requirements listed on the Electronic Console interface and as listed in the owner's manual). This is accomplished utilizing a basic pool care test kit which you can purchase at any local pool supply store. (Remember: pH is lowered by adding pool acid. TA is raised by adding sodium bicarbonate aka Baking Soda. Note: Do not add soda ash to your pool water).
Check your copper level weekly utilizing the supplied ClearSwim copper test kit. (Additional copper test kits can be purchased here). To adjust the copper level in your pool locate the copper level buttons on your Electronic Console and adjust accordingly. Refer to owner’s manual for instructions.
TDS, Ca Hardness (Calcium Hardness) and Total Hardness should be monitored and maintained at the specified requirements listed on your Electronic Console interface.
In some areas calcium levels are more severe than others and the Clear 10 Emitter Chamber plates may require cleaning quarterly. Here’s how: Remove the Emitter Chamber, Use the supplied end cap to cap the end opposite of the turbo blade, then fill chamber (through turbo blade opening) with a mixture of 3:1 Water:Pool Acid (75% water, 25% pool acid) until plates are covered, Let sit for approximately 10 minutes, Empty and rinse with garden hose. Re-install Emitter Chamber.